Home/Al-Mukhtar Journal of Engineering Research/Article Record
Peer-Reviewed Article May 9, 2024

Modelling and simulation of flexural behavior for reinforced concrete beams using ANSYS

Are you an author of this work?Link to your sovereign AfriScholar profile
Published in: Al-Mukhtar Journal of Engineering Research
Publisher: Omar Al-Mukhtar University • Libya • 3006-791X
DOI: https://doi.org/10.54172/mx8n6k70

Abstract

Over the last twenty years, many investigators are used finite element software, to validate and compare the FE results with their experimental research. This work focused on the development of a numerical model implemented by the ANSYS 2022R2 software, to simulate the flexural behavior of the RC beam. Numerical models are tested under four-point bending. To investigate the influence of reinforcement steel ratio and compressive strength of concrete on the flexural capacity of the model. The results indicated that the Finite Element model was able to predict the flexural behavior of the experimental test beam. Furthermore, the influence of different tensile reinforcement ratios has the most effect on the flexural behaviour of the FE models at maximum loads. While the change in concrete compressive strength has affected the flexural performance of the models. This influence shows slight increases in the first crack load and maximum loads of the models. Furthermore, cracking pattern behaviour at the final stage for numerical models showed a good agreement with experimental cracks behaviour.

Download Full Text PDFView at PublisherCrossref RecordCrossref XML

Verified Citation Velocity

Recorded scholarly citations in African and international peer-reviewed literature

3
Total Citations

Citations are continuously tracked and harvested across continental OJS endpoints and OpenAlex feeds.